Page 1 of 1

Metin2 config file: metin2.cfg resolution, frequency, windowed mode, and the read-only fix

Posted: Sun Nov 22, 2026 1:02 am
by admin
Quick summary
  • metin2.cfg sits in the main Metin2 folder and holds the display settings, including WIDTH, HEIGHT and FREQUENCY.
  • Blank or zero values in those fields can make the game reject the settings with a parameters message.
  • Adding WINDOWED 1 on its own line runs the game in a window.
  • Replies in the thread suggest saving the file and then marking it Read-only so the edited values survive a restart.
  • An empty FREQUENCY field needs a number, and one reply uses 60.
The problem described in the thread
A player with a 15.6 inch 165Hz laptop reported that the game would not switch from full screen to windowed mode and that pressing Ok produced a message saying the parameters were not correct.
Further replies in the same thread pointed at blank fields in the config file and at a missing WINDOWED entry, and one player confirmed the fix worked after adding it.

Steps reported in the thread
  • Open the main Metin2 folder and edit metin2.cfg with Notepad.
  • Set WIDTH and HEIGHT to the monitor resolution and set FREQUENCY. None of the three should be 0.
  • Save metin2.cfg, then mark the file Read-only in its properties and restart the game.
  • To force windowed mode, add a new line with WINDOWED 1 at the end of the file. One reply shows it added after CAMERA_MODE 0.
  • If FREQUENCY is empty, fill in a value such as 60.
  • Every empty field needs a value, even when it does not look relevant.
Notes on the source
These steps come from a Technical Support thread on the official Metin2 board, not from a Gameforge knowledge base article, and the case in the thread is the Gameforge client.
Keep a copy of the original file so you can restore it if the game rewrites the config on the next launch.

FAQ
  • Where is metin2.cfg? In the main Metin2 directory, the folder the game runs from.
  • Why do the settings fail? The thread ties the error to zero or blank values, with FREQUENCY called out more than once.
  • How do I get windowed mode? Add WINDOWED 1 as its own line in metin2.cfg.
  • Why mark the file Read-only? So the edited values stay in place when the game starts again.
  • Will this work on any server? The thread covers the official Gameforge client, so check what your own client writes before relying on it.
Sources